BOBCAT Error Code Logo

Bobcat S185 50-41 Error Code

50-41 Fault Code Meaning :

Rear Drive Pwm Solenoid No Signal

50-41 Error Code

Rear Drive Pwm Solenoid No Signal is the main cause of 50-41 error.50-41 code needs proper lubrication of your transmission's moving parts, it's important to always drive with the right amount of clean fluid. It's good practice to periodically scan over the ground where your truck has been parked and check for signs of fluid leaks.

Bobcat S185 Photo

Tip For S185 Model

When an engine is running in an enclosed area, fresh air must be added to avoid concentration of exhaust fumes. If the engine is stationary, vent the exhaust outside. Exhaust fumes contain odorless, invisible gases which can kill without warning.

Do not engage the starter for longer than 15 seconds at a time. Longer use can damage the starter by overheating. Allow starter to cool for one minute before using starter again.

About | Contact | Privacy

Copyright © 2019 All rights reserved.

Bobcat Error Code

This website is not official or registered website. Please go official Bobcat website.

Sitemaps : 1-2-3-4-5