Bobcat S185 U1090-51 Error Code
U1090-51 Error Code
Hub Controller Not Programmed is the main cause of U1090-51 error.U1090-51 code needs proper lubrication of your transmission's moving parts, it's important to always drive with the right amount of clean fluid. It's good practice to periodically scan over the ground where your truck has been parked and check for signs of fluid leaks.
Tip For S185 Model
The overload warning device (if equipped) senses
hydraulic pressure in the boom lift circuit. When the
hydraulic pressure in the boom lift circuit reaches a
predetermined pressure setting, a buzzer will sound that
indicates an overload condition.
If the buzzer sounds, immediately move the arm closer to
the excavator and lower the boom. Reduce the size of the
load before attempting to re-lift the load.